You can invoke the InfoServer in the following ways:

    o  Using the RUN command

       As explained in the introduction, you can invoke the
       InfoServer using the RUN command by entering the following
       at the DCL command prompt:

       $ RUN SYS$SYSTEM:ESS$INFOSERVER

    o  Defining the InfoServer as a foreign command

       You can also define the InfoServer as a foreign command by
       entering the following at the DCL prompt, or in a startup or
       login command file:

       $ InfoServer :== $ESS$INFOSERVER

       After you enter this definition, you can enter the InfoServer
       command at the DCL prompt to invoke the utility:

       $ InfoServer

       If you use InfoServer as a foreign command:

       -  And also enter an InfoServer command, the utility
          terminates after it executes the command and returns you
          to the DCL command prompt; for example:

          $ InfoServer SHOW SERVER
             .
             .
             .
          (output)
             .
             .
             .
          $

       -  Without specifying an InfoServer command, the utility
          displays the InfoServer> prompt, at which point you can
          enter commands; for example:

          $ InfoServer
          InfoServer>  SHOW SERVER
             .
             .
             .
          (output)
             .
             .
             .

    When you are inside the InfoServer utility, you can enter HELP to
    get help on InfoServer commands.

                                   NOTE

       All InfoServer commands require SYSPRV and OPER privileges.

    To exit from the InfoServer utility, enter the EXIT command at
    the InfoServer> prompt or press Ctrl/Z.

    For information about the InfoServer utility, enter the HELP
    command at the InfoServer> prompt.