Use the SET MODULE X25-PROTOCOL command to create or modify the
 parameters of the Protocol Module component in the volatile data
 base. Use the DEFINE MODULE X25-PROTOCOL command to create or modify
 the parameters of the Protocol Module component in the permanent data
 base.

 Use separate SET MODULE X25-PROTOCOL commands to a specify a DTE with
 its associated parameters, a group with its associated parameters and
 the network profile.

     SET  MODULE X25-PROTOCOL  DTE dte-address    NETWORK network-name
                                 KNOWN DTES       KNOWN NETWORKS
                                                  ALL
                                                  CALL TIMER seconds
                                                  CHANNELS list
                                                  CLEAR TIMER seconds
                                                  COUNTER TIMER seconds
                                                  DEFAULT DATA bytes
                                                  DEFAULT WINDOW count
                                                  INTERFACE code
                                                  INTERRUPT TIMER seconds
                                                  LINE line-id
                                                  MAXIMUM CIRCUITS count
                                                  MAXIMUM CLEARS count
                                                  MAXIMUM DATA bytes
                                                  MAXIMUM RESETS count
                                                  MAXIMUM RESTARTS count
                                                  MAXIMUM WINDOW count
                                                  RESET TIMER seconds
                                                  RESTART TIMER seconds
                                                  STATE ON
                                                        OFF
                                                        SHUT

                                 GROUP group-name  ALL
                                 KNOWN GROUPS      DTE dte-address
                                                   NETWORK net-name
                                                   NUMBER group-number
                                                   TYPE BILATERAL

                                 NETWORK net-name  PROFILE profile-name
                                 KNOWN NETWORKS

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.