Use the DISCONNECT command to disconnect logical links active  on  the
 executor node.

 DISCONNECT KNOWN LINKS     WITH NODE node-id
            LINK number

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

1  –  KNOWN LINKS

 Indicates that all links are to be disconnected.

2  –  LINK number

 Identifies the particular logical link to be disconnected.
 Use a number in the range of 1 to 65535.

3  –  WITH NODE node-id

 Identifies the node with which all logical links are to be
 disconnected. The node-id is either a node name or a node
 address.  This is only valid when used with KNOWN LINKS.

4  –  Examples

 NCP>DISCONNECT LINK 1840

 This command disconnects link 1840.

 NCP>DISCONNECT KNOWN LINKS WITH NODE TRNTO

 This command disconnects all  active  links  to  remote  node
 TRNTO.