1.$ STOP/QUEUE  LPA0
      $ START/QUEUE/TOP_OF_FILE  LPA0

      The STOP/QUEUE command in this example suspends the job that is
      currently executing on the printer queue LPA0 and places that
      queue in the paused state. The START/QUEUE command releases the
      queue from the paused state. The /TOP_OF_FILE qualifier causes
      the job that was suspended to resume printing at the beginning
      of the file rather than at where it was interrupted.

    2.$ INITIALIZE/QUEUE  LPA0
         .
         .
         .
      $ START/QUEUE/DEFAULT=FLAG  LPA0

      The INITIALIZE/QUEUE command in this example initializes the
      queue named LPA0. Later, the START/QUEUE command starts the
      queue. The /DEFAULT qualifier requests that a flag page precede
      each file in each job.

    3.$ START/QUEUE/DEFAULT=FORM=LN01_PORTRAIT LN01_PRINT

      The START/QUEUE command in this example restarts the LN01_PRINT
      queue with the default form LN01_PORTRAIT.

    4.$ INITIALIZE/QUEUE/START/GENERIC=(A,B)  MYQUEUE
      .
      .  [new printers X and Y are brought in at a later date]
      .
      $ STOP/QUEUE/NEXT MYQUEUE
      $ START/QUEUE/GENERIC=(X,Y) MYQUEUE

      This example changes the list of target nodes for a generic
      queue. Note that the queue was previously initialized as a
      generic queue.

    5.$ START/QUEUE/RAD=1 BATCHQ1

      $ SHOW QUEUE/FULL BATCHQ1
      Batch queue BATCHQ1, idle, on QUEBID::
       /BASE_PRIORITY=4 /JOB_LIMIT=3 /OWNER=[SYSTEM]
       /PROTECTION=(S:M,O:D,G:R,W:S) /RAD=1

      This example modifies BATCHQ1 to run all assigned jobs on RAD 1
      of QUEBID, and readies the queue to accept jobs for processing.