DESTINATION
         Support: L2,IP

         The IP address and subnet mask to which this reachable address refers.
         This value is derived from the destination argument of the create
         command. You cannot modify this  characteristic.

     DTE ADDRESSES
         Support: L2,IP
         Default: No DTE addresses            Value: Set of DTE addresses

         A set of DTE addresses to which a call may be directed in order to
         reach an address that matches the subnet address given by the  subnet
         address characteristic. You can modify this  characteristic only when
         the entity is disabled. This characteristic is supported only if the
         owning circuit is an X.25 circuit.

     METRIC
         Support: L2,IP
         Default: 20                           Value: 1-maximum link cost

         Default metric value for reaching the specified subnet over this
         circuit. You can modify this characteristic only when the entity is
         disabled.

     METRIC CLASS
         Support: L2,IP
         Default: External                     Value: External or Internal

         Class of the default metric, which controls the preference for this
         route in the decision process.

         EXTERNAL - The I/E bit for the default metric in the External
                    Reachability Information option of level 2 link state
                    packets is set to 1. The subnet address specified by this
                    IP reachable address will have the same preference as level
                    2 external routes.
         INTERNAL - The I/E bit for the default metric in the External
                    Reachability Information option of level 2 link state
                    packets is set to 0. The subnet address specified by this
                    IP reachable address will have the same preference as level
                    2 internal routes.

         You can modify this characteristic only when the entity is disabled.

     NEXT HOP
         Support: L2,IP
         Default: 0.0.0.0                           Value: Ip-address

         IP address of the neighboring node through which the destination is
         reachable. When you create this entity, this characteristic is set to
         the value of the IP address component of the  destination argument
         of the  create command if the IP reachable address is to an IP host.
         This characteristic is not used on circuits of type x25 da. You can
         modify this characteristic only when the entity is disabled.