Library /sys$common/syshlp/NCPHELP.HLB  —  SET  LINE
 Use the SET LINE command to create or modify line  parameters  in  the
 volatile  database on the executor node.  Use the DEFINE LINE command to
 create or modify line parameters in the permanent  data base  on  the
 executor node.

 SET     KNOWN LINES     (parameters ...)
         LINE line-id

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.
Additional Information: explode extract
KNOWN LINES LINE line-id ALL BUFFER SIZE CLOCK mode CONTROLLER COUNTER TIMER seconds DEAD TIMER milliseconds DELAY TIMER milliseconds DUPLEX ECHO HANGUP option INTERFACE code LINE SPEED speed MAXIMUM MICROCODE DUMP file-spec NETWORK net-name NIF TARGET address PROTOCOL RECEIVE BUFFERS number REQUESTED TRT microseconds RESTRICTED TOKEN TIMEOUT milliseconds RETRANSMIT TIMER milliseconds RING PURGER ENABLE option SCHEDULING TIMER milliseconds SERVICE TIMER milliseconds SIF STATE STREAM TIMER milliseconds SWITCH option VALID TRANSMISSION TIME microseconds Examples
Close Help