/sys$common/syshlp/NCPHELP.HLB  —  SET  CIRCUIT
 Use the SET CIRCUIT command to create or modify circuit parameters
 in the volatile database.  Use the DEFINE CIRCUIT command to
 create or modify permanent circuit parameters.

 SET     KNOWN CIRCUITS       (parameters ...)
         CIRCUIT circuit-id

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.
Additional Information: explode extract
KNOWN CIRCUITS CIRCUIT circuit-id ALL ACTIVE BABBLE TIMER CHANNEL number COUNTER TIMER COST DEAD THRESHOLD DTE dte-address DYING HELLO TIMER INACTIVE MAXIMUM NETWORK network-name NUMBER dte-address OWNER EXECUTOR POLLING STATE RECALL TIMER ROUTER PRIORITY SERVICE STATE TRANSMIT TIMER TRIBUTARY TYPE X25 USAGE VERIFICATION Examples
Close Help