/sys$common/syshlp/NCPHELP.HLB  —  EVENTS
 The following is the list of events that can be reported with event
 logging.  Not all events are generated by DECnet for OpenVMS, but if a
 DECnet for OpenVMS system acts as a sink node for another system, it
 may report any of these events.

 0.0  Event records lost
 0.1  Automatic node counters
 0.2  Automatic line counters
 0.3  Automatic line service
 0.4  Line counters zeroed
 0.5  Node counters zeroed
 0.6  Passive loopback
 0.7  Aborted service request
 0.8  Automatic counters
 0.9  Counters zeroed

 2.0  Local node state change
 2.1  Access control failure

 3.0  Invalid message
 3.1  Invalid flow control
 3.2  Data base reused

 4.1  Node unreachable packet loss
 4.2  Node out-of-range packet loss
 4.3  Oversized packet loss
 4.4  Packet format error
 4.5  Partial routing update loss
 4.6  Verification reject
 4.7  Circuit down, circuit fault
 4.8  Circuit down
 4.9  Circuit down, operator initiated
 4.10 Circuit up
 4.11 Init failure, line fault
 4.12 Init failure
 4.13 Init failure, operator initiated
 4.14 Node reachability change
 4.15 Adjacency up
 4.16 Adjacency rejected
 4.17 Area reachability change
 4.18 Adjacency down
 4.19 Adjacency down, operator initiated

 5.0 Locally initiated state change
 5.1 Remotely initiated state change
 5.2 Protocol restart received in maintenance mode
 5.3 Send error threshold
 5.4 Receive error threshold
 5.5 Select error threshold
 5.6 Block header format error
 5.7 Selection address error
 5.8 Streaming tributary
 5.9 Local buffer to small
 5.13 Line initialization error
 5.14 Send failure on line
 5.15 Receive failed on line
 5.16 Collision detect check failed on line
 5.17 DTE up
 5.18 DTE down
 5.19 Retransmit maximum exceeded
 5.20 FRMR received
 5.21 Illegal frame received

 7.0 DTE state change
 7.1 Illegal packet received
 7.2 Invalid LCN
 7.3 Flow control invalid
 7.4 Restart
 7.5 Clear
 7.6 Reset
 7.7 Diagnostic
 7.8 Reject
 7.9 Retransmission maximum exceeded
 7.10 Call failed
 7.11 State change

 128.1 DAP CRC error detected
 128.2 Duplicate Phase 2 address error
 128.3 Process created
 128.4 Process terminated
Close Help