Use the CONNECT NODE command to set up a logical connection between
 the host node and the console interface on a specified target node.
 Both the host node and the target node must be on the same broadcast
 circuit.

 Use the SET NODE command to initially specify the default
 values for the SERVICE CIRCUIT, SERVICE PASSWORD, and HARDWARE ADDRESS
 parameters for the target node.  Once set, you can override these
 default parameters for the target node by specifying new parameters in
 the CONNECT command.

 CONNECT NODE node-id    (parameters ...)

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.