/PVC=(vci[,...])
       /[NO]PVC=(vci[,...])

    Sets the permanent virtual circuit (PVC) to be used by a
    Classical IP over ATM client. This is an optional qualifier.

    A list of PVCs is defined for use by CLIP clients. This command
    should be used before enabling the CLIP client. The PVC has to be
    set up manually in the ATM switch.

    The vci is the VCI (Virtual Circuit ID) of the PVC to be used.

    Examples

  1. LANCP> SET DEVICE/CONTENDER/MEDIA=UTP/NOEARLY/SOURCE ICA0

    Enables monitor contention, UTP cable media, source routing and
    disables early token release for Token Ring device ICA0.

  2. LANCP> SET DEVICE/MEDIA=TWI EWB0

    Sets the media type to twisted pair for the second Tulip Ethernet
    device, EWB0.

  3. LANCP> SET DEVICE EXA0/MOPDLL=ENABLE

    Enables MOP downline load service for device EXA0, leaving the
    remaining MOPDLL parameters unchanged.

  4. LANCP> SET DEVICE EXA0/MOPDLL=(ENABLE,EXCLUSIVE,SIZE=1482)

    Enables MOP downline load service for device EXA0, in exclusive
    mode with the data transfer size of 1482 bytes, leaving the
    remaining MOPDLL parameters unchanged.

  5. LANCP> SET DEVICE EXA0/MOPDLL=(ENABLE,NOEXCLUSIVE)
  LANCP> SET DEVICE FXA0/MOPDLL=(ENABLE,EXCL,KNOWN)

    These commands enable LANACP MOP downline load service for:

    o  LAN device EXA0 in nonexclusive mode

    o  LAN device FXB0 in exclusive mode for only known clients