1    /CONFIRM

       /CONFIRM
       /NOCONFIRM (default)

    Controls whether SYSMAN displays the file specification of each
    file before adding it to the startup database and requests you to
    confirm the addition. If you specify /CONFIRM, you must respond
    to the prompt with a Y (Yes) or a T (True) and press Return
    before the file is added. If you enter anything else, such as
    N or No, the requested file is not added.

2    /LOG

       /LOG
       /NOLOG (default)

    Controls whether the STARTUP ADD command displays the file
    specification of each file after it has been added.

3    /MODE

       /MODE=mode

    Specifies the mode of execution for the file. Valid modes include
    DIRECT, SPAWN, BATCH, or ANY.

4    /NODE

       /NODE=(node1,node2,...,noden)

    Names the nodes within the cluster that run the file during
    startup. By default, a startup file executes on all nodes in
    the cluster.

5    /PARAMETER

       /PARAMETER=(P1:arg1,P2:arg2,...,P8:arg8)

    Specifies the parameters that are to be passed to the file
    during startup. Parameters that are omitted receive the default
    parameters defined by the system parameter STARTUP_Pn. If
    STARTUP_Pn is blank, "FULL" is used as parameter 1 (P1) and is
    passed by STARTUP.COM to each startup component file. If you want
    a blank P1 parameter given to a specific component file, use the
    command:

    SYSMAN> STARTUP MODIFY FILE component.com/PARAM=P1:""

6    /PHASE

       /PHASE=phase-name

    Indicates the phase within system startup when the file is to be
    executed. Valid phases include LPBEGIN, LPMAIN, LPBETA, and END.
    LPMAIN is the default.