1    /CLUSTER

    Specifies that all subsequent commands apply to all nodes in
    the cluster. By default, the management environment is the local
    cluster. Specify a nonlocal cluster by naming one cluster member
    with the /NODE qualifier.

2    /NODE

       /NODE=(node1,node2,...)

    Specifies that SYSMAN execute subsequent commands on the given
    DECnet nodes. If accompanied by the /CLUSTER qualifier, the
    environment becomes the cluster where the given DECnet node is
    a member. A node name can be a system name, cluster alias, or
    logical name. However, before you can use logical names to define
    the command environment, you must set up the logical name table
    SYSMAN$NODE_TABLE. For more information about defining the SYSMAN
    logical name table, see the HP OpenVMS System Manager's Manual.

3    /USERNAME

       /USERNAME=username

    Specifies that this user name should be used for access control
    purposes on another node. You can use this qualifier only in
    conjunction with the /CLUSTER or /NODE qualifiers. SYSMAN uses
    the current user name if none is supplied. SYSMAN prompts for a
    password whenever you specify a new user name.

                                   NOTE

       The account specified must have only a primary password.
       Accounts with secondary passwords are not supported.