1  –  MOP

1.1  –  Circuit

    Toggle buttons in the on state (filled in) represent those MOP
    functions enabled for the circuit.  Toggle buttons in the off state
    (empty) represent those MOP functions disabled for the circuit.

    To enable a function, click on the associated toggle button until that
    button is in the on state.

    To disable a function, click on the associated toggle button until that
    button is in the off state.

    Once you have determined that all the toggle buttons are in their proper
    states, press the CONTINUE button to cause the appropriate Enable and
    Disable commands to be issued.  Or press the CANCEL button to cancel the
    operation.  In either case, you will be returned to the main window.

2  –  Node

    Toggle buttons in the on state (filled in) represent those functions
    enabled for the Node.  Toggle buttons in the off state (empty) represent
    those functions disabled for the Node.  To enable a function, click on
    the associated toggle button until that button is in the on state.
    To disable a function, click on the associated toggle button until that
    button is in the off state.  The functions are:

    Address        Enables the address watcher function. Enabling
    Watcher        this function allows the node to update its
                   address identifier when a change of address is
                   detected.

                   Disabling this function causes the state attribute
                   to be set to off, but the node can still respond to
                   management through its CMIP interface.

    CMIP           Enabled automatically by the software. This
    Listener       function permits the node to respond to management
                   through its CMIP listener interface.

    Once you have determined that all the toggle buttons are in their proper
    states, press the CONTINUE button to cause the appropriate enable and
    disable commands to be issued.  Or press the CANCEL button to cancel the
    operation.  In either case, you will be returned to the main window.