NCPHELP.HLB  —  TRIGGER  NODE
 Use the TRIGGER NODE command to trigger the bootstrap mechanism  of  a
 target  node such that the node will load itself.  Use this command to
 initiate the loading sequence for  an  unattended  system.

 TRIGGER NODE node-id    SERVICE PASSWORD hex-password
                         VIA circuit-id
                         PHYSICAL ADDRESS address

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

1  –  NODE node-id

 Identifies the node whose bootstrap is to be triggered.

2  –  PHYSICAL ADDRESS

 Applies only to nodes on broadcast circuits.  Specifies the physical
 address that the target node currently use to identify itself.
 The value is the physical address the target node has set for
 itself, or, if the target node has not set a physical address, the
 HARDWARE ADDRESS parameter if associated with the target node in the
 executor node's volatile database.

3  –  SERVICE PASSWORD hex-password

 Identifies the password required to trigger the bootstrap
 mechanism on the target node.

4  –  VIA circuit-id

 Identifies the circuit over which the operation is to take
 place.

5  –  Examples

      NCP>TRIGGER NODE NYC

          This command triggers the bootstrap mechanism on node NYC  to
          initiate a downline load operation.

      NCP>TRIGGER NODE NYC SERVICE PASSWORD F0F0 VIA DMC-5

          This command provides a service password in order to  trigger
          the  bootstrap  mechanism on node NYC and initiate a downline
          load operation over circuit DMC-5.
Close Help