1  –  CIRCUITS count

 Specifies the maximum number of circuits for the DTE. By default, the
 maximum is 255.

2  –  CLEARS count

 Specifies the maximum number of attempts to clear an X25 virtual
 circuit. Specify a value in the range 1 to 255. By default the value
 is the network value specified by the PROFILE parameter.

3  –  DATA bytes

 Specifies the maximum packet size for X25 virtual circuits. This
 value must be at least 5 bytes less than the MAXIMUM BLOCK value you
 specify in the SET LINE command and must be a power of 2. Specify a
 value in the range 16 to 4096 bytes.

 By default the value taken is the network value specified by the
 PROFILE parameter.

4  –  RESETS count

 Specifies the maximum number of attempts to reset an X25 virtual
 circuit. Specify a value in the range 1 to 255.

 By default, the count takes the network value specified by the PROFILE
 parameter.

5  –  RESTARTS count

 Specifies the maximum number of attempts to restart an X25 virtual
 circuit. Specify a value in the range 1 to 255.

 By default, the count takes the network value specified by the PROFILE
 parameter.

6  –  WINDOW count

 Specifies the window size allowed for X25 virtual circuits, that is,
 the maximum number of packets for which outstanding acknowledgments
 are allowed. Specify a value in the range 1 to 127.

 By default, the window size takes the network value specified by the
 PROFILE parameter.