Use the CONNECT VIA command to set up a logical connection between
 the host node and the console interface on a target node using the
 specified circuit.  Use the CONNECT VIA command instead of the CONNECT
 NODE command if the node address of the target node is not known.  Both
 the host node and the target node must be on the same broadcast circuit.

 CONNECT  VIA circuit-id   (parameters ...)

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

1  –  Examples

      NCP>CONNECT VIA UNA-0 PHYSICAL ADDRESS AA-00-04-00-38-00

          This command connects the host node to the console interface
          on the target node  by specifying the circuit over which the
          connection is to be made and the physical address of the
          target node.

2  –  PHYSICAL ADDRESS

 Specifies the physical address of the target node.  This parameter is
 required.  The value is the physical address the target node has set
 for itself.

3  –  SERVICE PASSWORD

 Identifies the password required to create the logical link between
 the host node and the target node.  The password is a hexadecimal
 number in the range 0 to FFFFFFFFFFFFFFFF.