NCLHELP.HLB  —  show  routing  circuit  Counters
 o  authentication failures

    Support: L1,L2,IP

    Number of times a PDU has been received on this circuit with an
    Authentication Information field that is incompatible with the
    PDU type.

 o  calls failed

    Support: All

    Number of unsuccessful call attempts on this circuit. This
    attribute is supported only if the characteristic type is x25
    da.

 o  calls placed

    Support: All

    Number of call attempts (successful and unsuccessful) on this
    circuit. This attribute is supported only if the characteristic
    type is x25 da.

 o  changes in adjacency state

    Support: All

    Number of times the status attribute state of an adjacency
    belonging to this circuit changes from Up to Down (or
    Initializing), or the reverse.

 o  changes in ip adjacency state

    Support: IP

    Number of times the status attribute state of an IP adjacency
    belonging to this circuit changes from Up to some other state, or
    the reverse.

 o  changes in rip neighbor state

    Support: L2,IP

    Specifies the number of times the RIP state of IP adjacencies
    belonging to this circuit have changed. This attribute is
    supported only if the routing entity's characteristic routing
    protocols supported includes the routing protocol RIP.

 o  circuit changes

    Support: All

    Number of times that the status attribute state has changed from
    on to off, or vice versa.

 o  congestion discards

    Support: L1,L2

    Number of data-and error-report NPDUs that have been discarded,
    before or after fragmentation, because of congestion. Any other
    discarding will already have been done by the forwarding process.
    This number includes all PDUs recognized by the receive process
    as data PDUs (DECnet-Plus data- and error-report PDUs and Phase IV
    data packets), even though they may subsequently be discarded for
    some reason.

 o  control pdus received

    Support: All

    Number of control PDUs that have been received on this circuit.
    This number includes all Network layer PDUs, with the exception
    of DECnet-Plus data and error report PDUs and Phase IV data PDUs.

 o  control pdus sent

    Support: All

    Number of control PDUs that have been sent on this circuit.

 o  corrupted lsps received

    Support: L1,L2

    Number of times a corrupted link state packet has been received
    on this circuit.

 o  corrupted hello pdus received

    Support: All

    Number of times an ES-IS (end system to intermediate system) or
    IS-IS (intermediate system to intermediate system) Hello PDU has
    been received on this circuit that either cannot be parsed or
    contains an incorrect checksum.

 o  creation time

    Support: All

    Time this entity was created.

 o  da adjacency changes

    Support: All

    Number of DA adjacency change events that have been generated.

 o  data pdus forwarded

    Support: L1,L2

    Number of data- and error-report NPDUs that have been forwarded
    onto this circuit (either from another circuit or from a local
    port). This number includes all PDUs recognized by the receive
    process as data PDUs (DECnet-Plus data- and error-report PDUs
    and Phase IV data packets), even though they may subsequently be
    discarded for some reason.

 o  data pdus fragmented

    Support: All

    Number of data NPDUs that have been fragmented on this circuit.

 o  data pdus received

    Support: All

    Number of data- and error-report NPDUs that have been received
    on this circuit. This number includes all PDUs recognized by
    the receive process as data PDUs (DECnet-Plus data and error
    report PDUs and Phase IV data packets), even though they may
    subsequently be discarded for some reason.

 o  data pdus transmitted

    Support: All

    Number of data- and error-report NPDUs, after fragmentation, that
    have been delivered to the port for transmission on this circuit.
    This number includes all PDUs recognized by the receive process
    as data PDUs (DECnet-Plus data- and error-report PDUs and Phase IV
    data packets), even though they may subsequently be discarded for
    some reason.

 o  exceeded maximum svc adjacencies

    Support: End,L2

    Number of exceeded maximum svc adjacency events that have been
    generated. This counter is supported only if the circuit's type
    is set to x25 da; only for nodes that are end nodes; and if the
    system supports dual routing (both DECnet and IP routing).

 o  id reachablity changes

    Support: All

    Number of ID reachability change events that have been generated.

 o  initialization failures

    Support: All

    Number of times that an attempt to initialize an adjacent node
    over this circuit has failed, either because of version skew or
    area mismatch.

 o  ip fragmentation failure discards

    Support: IP

    Number of IP packets discarded because fragmentation was required
    to transmit them, but the IP header requested "do not fragment."
    This attribute is supported only if the system supports dual
    routing (both DECnet and IP routing).

 o  ip fragments created

    Support: IP

    Number of IP fragments created for transmission on this circuit.

 o  ip packets forwarded

    Support: IP

    Number of IP packets forwarded on this circuit before
    fragmentation. These IP packets may be from another circuit or
    from a local port. Note that this value includes those IP packets
    counted in the ip send discards counter.

 o  ip packets fragmented

    Support: IP

    Number of IP packets that have been fragmented on this circuit.

 o  ip packets received

    Support: IP

    Number of IP packets received on this circuit. This value
    includes all types of IP packet (control, data, etc.), and those
    that may subsequently be discarded for any reason.

 o  ip received discards

    Support: IP

    Number of IP packets that have been received and then discarded
    because of congestion.

 o  ip send discards

    Support: IP

    Number of IP packets for transmission that have been discarded
    because of congestion.

 o  irrecoverable svc failures

    Support: All

    Number of times that the number of re-call attempts on this
    circuit has become equal to the value of the characteristic
    maximum call attempts. This attribute is supported only if the
    characteristic type is set to x25 static outgoing.

 o  LAN l1 designated router changes

    Support: L1,L2

    Number of times the local node has either elected itself or
    resigned as the LAN level 1 designated router on this circuit.
    This attribute is supported only if the circuit's characteristic
    type is set to csma-cd.

 o  LAN l2 designated router changes

    Support: L2

    Number of times the local node has either elected itself or
    resigned as the LAN level 2 designated router on this circuit.

 o  LAN phaseiv designated router changes

    Support: L1,L2

    Number of times the local node has either elected itself or
    resigned as the LAN Phase IV designated router on this circuit.

 o  redirect discards

    Support: End

    Number of Redirect PDUs that have been discarded because of
    insufficient cache memory.

 o  rejected adjacencies

    Support: All

    Number of times an attempt to create a new adjacency using this
    circuit has failed because of insufficient resources.

 o  rejected ip adjacencies

    Support: L2,IP

    Number of times an attempt to automatically create a new
    IP adjacency to an IP router has failed because of lack of
    resources.

 o  rip errors received

    Support: L2,IP

    Number of RIP messages received with any kind of received error
    on this circuit. This attribute is supported only if the routing
    entity's characteristic routing protocols supported includes the
    routing protocol RIP.

 o  segmentation failure discards

    Support: L1,L2

    Number of data NPDUs that have been discarded because
    segmentation was required to send them on this circuit but was
    not permitted in the NPDU header.

 o  verification reject events

    Number of verification reject events that have been generated.
    This attribute is supported only if the characteristic type is
    set to ddcmp, hdlc, x25 static incoming, x25 static outgoing, or
    x25 permanent.
Close Help