NCLHELP.HLB  —  enable  xot (OpenVMS Alpha), sap
    enable  [node node-id] xot sap sap-name

    Enables a Service Access Point (SAP) entity of the X.25 Over
    TCP/IP (XOT) module.  The sap-name is a simple name which
    unqiuely identifies a particular SAP instance.

    Before enabling a SAP entity, you should check the local ip
    addresses of any existing SAP entities.  The local ip address
    of 0.0.0.0 specifies that the SAP may listen on any available
    IP interface.  This local ip address of 0.0.0.0 should only
    be specified if a single SAP is in use.

    Example:

    show xot sap * -            ! To see what ip interfaces the
      local ip address, state   !   existing SAPs listen to.
    enable xot sap sap-1

1  –  link

    enable  [node node-id] xot sap sap-name link link-name

    Enables a XOT SAP LINK entity which represents a remote system
    with which XOT is allowed to communicate.  The sap-name and
    link-name are simple names which uniquely identify particular
    SAP and LINK instances.

    In the case of an inbound XOT connection, there must be a LINK
    entity with a matching remote IP address and remote port
    number in order for XOT to accept the TCP/IP connection.

    In the case of an outbound connection, the LINK entity
    specifies the remote IP address and remote port number of the
    system with which to attempt the TCP/IP connection.

    Example:

    enable xot sap sap-0 link link-0

1.1  –  Exception messages

 o  remote address in use

    Remote port number and remote IP address being used.
Close Help