HELPLIB.HLB  —  SET  ENTRY  Examples
    1.$ PRINT/HOLD   MYFILE.DAT
        Job MYFILE (queue SYS$PRINT, entry 112) holding
      $ SET ENTRY 112/RELEASE/JOB_COUNT=3

      The PRINT command in this example requests that the file
      MYFILE.DAT be queued to the system printer, but placed in
      a hold status. The SET ENTRY command releases the job for
      printing and requests that three copies of the job be printed.

    2.$ SUBMIT CLIMATE
        Job CLIMATE (queue SYS$BATCH, entry 211) pending
      $ SET ENTRY 211/HOLD/NAME=TEMP

      The SUBMIT command in this example queues the command procedure
      CLIMATE.COM for processing as a batch job. The SET ENTRY
      command places the job in a hold state and changes the job name
      to TEMP, assuming that the job has not yet begun execution.

    3.$ PRINT/FLAG=ALL/AFTER=20:00 MEMO.MEM, LETTER.MEM, REPORT.MEM/SPACE
        Job MEMO (queue SYS$PRINT, entry 172) holding until 20:00
      $ SET ENTRY 172 /BURST/NOSPACE/HEADER

      The PRINT command in this example requests that three files be
      printed after 8:00 P.M. on the default printer with flag pages
      preceding each file. It also requests that the file REPORT.MEM
      be double-spaced. Later a SET ENTRY command calls for a burst
      page at the beginning of each file and requests that all files
      in the job be single-spaced. This command also requests that
      headers be printed on each page of each file in the job.

    4.$ SUBMIT/HOLD/QUEUE=ANYRADQ  TEST.COM
      Job TEST (queue ANYRADQ, entry 23) holding

      $ SET ENTRY 23 /RAD=1
      $ SHOW ENTRY/FULL 23
       Entry  Jobname         Username     Blocks  Status
       -----  -------         --------     ------  ------
          23  TEST            SYSTEM               Holding
           On idle batch queue ANYRADQ
           Submitted 24-JUL-2001 14:19:37.44 /KEEP /NOPRINT /PRIORITY=100 /RAD=0
           File: _$1$DKB200:[SWEENEY.CLIUTL]TEST.COM;1

      In this example, TEST.COM is submitted to the queue ANYRADQ,
      and the SET ENTRY command is used to set the RAD to 1.
Close Help