1    /ADDRESS=lan-address

     Specifies the LAN address of the remote system.

2    /BREAK=break-character

     Specifies the character which is to be recognized as a request
     to send a MOP Break protocol command to the remote system.
     Pressing the Ctrl key and this character transmits a MOP Break
     to the remote system.  The default character is \.

3    /CIRCUIT=circuit-name

     Specifies the name of the MOP CIRCUIT entity over which the
     request should take place.

4    /DISCONNECT=disconnect-character

     Specifies the character which is to be recognized as a request
     to terminate the connection with the remote system.  Once the
     connection is established, pressing the Ctrl key and this
     character terminates the connection. The default character is ].

5    /VERIFICATION=hexidecimal-digits

     Specifies the service password of the remote system. A
     verification has 16 hex digits.  If less than 16 digits are
     specified, MOP will pad with zeros on the right.