Cancels a watchpoint.

    Format

      CANCEL WATCH  [address-expression[, . . . ]]

1  –  Parameters

 address-expression

    Specifies a watchpoint to be canceled. With high-level languages,
    this is typically the name of a variable. Do not use the asterisk
    (*)  wildcard character. Instead, use the /ALL qualifier. Do not
    specify an address expression with /ALL.

2  –  Qualifiers

2.1    /ALL

    Cancels all watchpoints.

3  –  Description

    The effect of the CANCEL WATCH command is symmetrical with the
    effect of the SET WATCH command. To cancel a watchpoint that was
    established at a specific location with the SET WATCH command,
    specify that same location with CANCEL WATCH. Thus, to cancel
    a watchpoint that was set on an entire aggregate, specify the
    aggregate in the CANCEL WATCH command; to cancel a watchpoint
    that was set on one element of an aggregate, specify that element
    in the CANCEL WATCH command.

    The CANCEL ALL command also cancels all watchpoints.

    To cause the debugger to temporarily ignore a watchpoint, but
    not delete the definition of the watchpoint, use the command
    DEACTIVATE WATCH. You can later activate the watchpoint (with
    ACTIVATE WATCH).

    Related commands:

       (ACTIVATE,DEACTIVATE,SET,SHOW) WATCH
       CANCEL ALL
       (SET,SHOW,CANCEL) BREAK
       (SET,SHOW,CANCEL) TRACE

4  –  Examples

    1.DBG> CANCEL WATCH SUB2\TOTAL

      This command cancels the watchpoint at variable TOTAL in module
      SUB2.

    2.DBG> CANCEL WATCH/ALL

      This command cancels all watchpoints you have set.