1  TRIGGER
 

2  NODE
   Issues a request to reboot to a remote node.

   Rather than specify the format to send MOP Version 3 or 4, the
   LANCP utility sends one message in each format to the target
   node.

   Format

     TRIGGER NODE  node-specification
 

3  Parameter
 

node-specification

   Supplies either the node name or the node address of the target
   node. If you supply the node name, the node address is obtained
   by looking up the node name in the LAN volatile node database. If
   you supply the node address, the corresponding node need not be
   defined in the LAN volatile node database. The canonical form of
   the address consists of 6 hexadecimal byte characters separated
   by hyphens. Use a colon as the separator character to indicate
   the bit-reversed form of the address.
 

3  Qualifiers
 

/DEVICE

      /DEVICE=device-name

   Specifies the LAN controller device name to be used for sending
   the trigger boot messages. For example, you can specify a DEMNA
   controller as EXA, EXA0 or EXA0:.
 

/PASSWORD

      /PASSWORD=16hexdigits

   Supplies the password to be used when the connection
   is initiated, in hexadecimal (for example,
   /PASSWORD=0123456789ABCDEF). The default password is zero. You
   can omit leading zeros.
 

3  Examples

   1.LANCP> TRIGGER NODE GALAXY/DEVICE=EWA0

     This command sends MOP trigger boot messages to node GALAXY
     using Ethernet device EWA0.

   2.LANCP> TRIGGER NODE 08-00-2B-11-22-33/DEVICE=EWA0/PASSWORD=0123456789AB

     This command sends MOP trigger boot messages to the given
     node address using the Ethernet device EWA0, with indicated
     password.