1  ENABLE
 

2  SERVICE
   Enables a service on the running TCP/IP Services software.

   Related commands: DISABLE SERVICE, SHOW SERVICE

   Format

     ENABLE SERVICE  [ service ]

                     [ /ADDRESS=IP_address ]

                     [ /PORT=n ]

                     [ /PROCESS=process ]

                     [ /PROTOCOL=protocol ]
 

3  Parameters
 

service

   Optional. Default: All services.

   Specifies the service to enable. The service must be defined
   in the services database. To specify a lowercase or mixed-case
   service name, enclose it in quotation marks.
 

3  Qualifiers
 

/ADDRESS

      /ADDRESS=IP_address

   Optional. Default: 0.0.0.0.

   Binds the service only to the specified address. If your host
   is multihomed, use this qualifier to configure the service to be
   offered on a specific Internet interface.
 

/PORT

      /PORT=n

   Optional. Starts the service on the specified port.
 

/PROCESS

      /PROCESS=process

   Optional.

   Runs the service as the specified process.
 

/PROTOCOL

      /PROTOCOL=protocol

   Optional. Default: TCP.

   Runs the service with the specified protocol.
 

3  Examples

   1.TCPIP> ENABLE SERVICE TELNET

     Initializes TELNET communications.

   2.TCPIP> ENABLE SERVICE RLOGIN /ADDRESS=130.180.4.7

     Starts the remote login service for users on the host with IP
     address 130.180.4.7.

   3.TCPIP> ENABLE SERVICE SMTP

     Starts the SMTP receiver. To start the SMTP sender, see
     the START MAIL command. For instructions on how to start
     the SMTP sender when TCP/IP Services starts up, see the SET
     CONFIGURATION ENABLE_SERVICE command.