1   LOCATE

             Format:
                     LOCATE <parameter>   

             When the above-mentioned command is executed, the LEDs of
             the requested drives will blink. These LEDs are visible from
             the front of the attached storage enclosures.

             Note: 
                  - If time limit is not included with the 
                    LOCATE command, the LEDs will blink for 
                    30 seconds. In some cases, the LEDs may 
                    not blink but will remain steady. 

                  - LOCATE command, does not work from the  
                    STANDBY CONTROLLER

2   ALL
   
             LOCATE All causes all the drives connected to the MSA
             storage sub-system to flash.


2   BOX

             LOCATE BOX causes the disks connected to the specified
             box/enclosure number to flash.                   


2   BUS

             LOCATE BUS causes the disks connected to the specified
             bus number to flash.  


2   CANCEL

             LOCATE CANCEL cancels the current locate operation.


2   DISKS    

             LOCATE DISKS will make the specified drive to flash.
             Disks are identified by their corresponding SCSI bus
             and SCSI IDs for all the controllers. For SAS controllers,
             internally connected disks are numbered based on their bay
             numbers and externally connected disks are numbered 
             based on combination of their box number and bay number 
             as "disk_n = box number *100 + bay number".

             Note: The disk numbers for the existing disks can be obtained 
                   using the SHOW DISKS command.

2   UNIT

             LOCATE UNIT causes the disks configured to the specified
             unit to flash. 


2   Qualifiers


3   /Time
         
             Time value contains the time interval for which the disk's
             LED should flash.

             Format:
                     /TIME=xxx-(optional) the length of time to flash
                     the LEDs, where xxx represents the number of seconds. 


3   /Verbose

             Provides logging that can be interpreted by engineering.


2   Examples

             - Locating all drives attached to the storage enclosure

               Example command
               LOCATE ALL


             - Locating all drives in a specific BOX

               Example command
               LOCATE BOX 1

               Command options:
               BOX 1 -  the drives in BOX 1 will be flashed.

             - Locating all drives for a specific SCSI bus

               Example command
               LOCATE BUS 1

               Command options:
               BUS 1 - all drives connected to bus number 1 will be flashed.


             - Locating all drives in a specific UNIT

               Example command
               LOCATE UNIT 1

               Command options:
               UNIT 1 - the drives in UNIT 1 will be flashed.


             - Locating specific drives

               Example command
               LOCATE DISK 102