1 ZERO

Use the ZERO commands to reset counters for circuits, lines, nodes and
the local node.

2 EXECUTOR

Use the ZERO EXECUTOR command to reset all counters for the
local node.

ZERO    EXECUTOR        COUNTERS

2 CIRCUIT

Use the ZERO CIRCUIT command to reset circuit counters on the
executor node.

ZERO    KNOWN CIRCUITS COUNTERS
        CIRCUIT circuit-id

All underscores found in parameters must be replaced with spaces
when parameters are used in NCP commands.
 
3 KNOWN CIRCUITS
Indicates that counters for all known circuits are to be reset.

3 CIRCUIT circuit-id
Identifies a particular circuit for which counters are to be
reset.

2 LINE

Use the ZERO LINE command to reset line counters on the
executor node.

ZERO    KNOWN LINES     COUNTERS
        LINE line-id

All underscores found in parameters must be replaced with spaces
when parameters are used in NCP commands.
 
3 KNOWN LINES
Indicates that counters for all known lines are to be reset.

3 LINE line-id
Identifies a particular line for which counters are to be
reset.

2 MODULE
Introduces a MODULE parameter.

3 X25-PROTOCOL
Zero the counters for a particular DTE or all KNOWN DTES.
The command for is :

ZERO MODULE X25-PROTOCOL DTE address     NETWORK network-name
                         KNOWN DTE       KNOWN NETWORK

All underscores found in parameters must be replaced with spaces
when parameters are used in NCP commands.
 
4 DTE dte-address
Zeroes the counters for the specified DTE only.

4 KNOWN DTES
Zeroes the counters for all known DTEs.

3 X25-SERVER
Zero the counters for the X25 Call Handler.

3 X29-SERVER
Zero the counters for the X.29 Call Handler.

2 NODE

Use the ZERO NODE command to reset node counters on the
executor node.

ZERO    KNOWN NODES     COUNTERS
        NODE node-id

All underscores found in parameters must be replaced with spaces
when parameters are used in NCP commands.
 
3 KNOWN NODES
Indicates that counters for all known nodes are to be reset.

3 NODE node-id
Identifies a particular node for which counters are to be
reset.

3 Examples

     NCP>ZERO NODE TRNTO COUNTERS

This command resets all node counters maintained on the
executor node for remote node TRNTO.
!
! end of NCPHELP.HLP
!